A Vance company - serving Weatherford, TX

FAAC Keypad & Intercom Repair Nationwide

Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Styles & brands we work with

Wrought iron
Wrought iron
Wood & steel frame
Wood & steel frame
Farm & ranch
Farm & ranch
Sliding driveway gates
Sliding driveway gates
LiftMaster operators
LiftMaster operators

Before & after – our own jobs

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

FAAC Keypad & Intercom Repair: The Weatherford Owner’s Guide

FAAC keypad and intercom repair in Weatherford typically runs $220 to $480 installed, depending on whether we’re replacing the keypad face, the control board behind it, or the intercom module itself. Most jobs are completed the same day we arrive because we keep FAAC-compatible keypads, weather seals, and intercom boards stocked on the truck. How most Weatherford homeowners discover the failure: the keypad stops responding to a code that worked yesterday, or the intercom audio goes dead right after a hard rain. In Parker County we see this constantly. The membrane on FAAC keypads degrades under the Texas sun, and once moisture gets behind it, the carbon contacts start shorting one row at a time.

Call (940) 353-4158

Key takeaways: we stock the parts on the truck, we price the repair in writing before we touch a single wire, and the 365-Day Done Right Promise covers every keypad and intercom repair we install.

Which FAAC Models This Applies To

We service the full FAAC residential and light commercial line that Weatherford properties actually use: the 400, 412, 415, 422, 450, and 750 series operators, plus the FAAC E024U and E124 control boards paired with DigiKey, Keypad, and DGA-1000 intercom modules. If your keypad says XKPR1, XKP-B, or just “FAAC” on the faceplate with a 12-key layout, we can match it. The compatibility gotcha most owners miss: FAAC keypads from the 400 series and the 750 series look nearly identical, but they communicate on different voltage rails. A 400-series keypad bolted onto a 750 board will light up, beep, and refuse to open the gate. We verify the board revision and measure the rail voltage before ordering or installing anything.

OEM versus aftermarket matters more with FAAC than with most brands. The FAAC weatherproofing on OEM faceplates is genuinely better; the rubber compound holds up longer in direct sun. Aftermarket equivalents work, but we tell Weatherford customers the truth: on a keypad that faces west or south, the OEM seal typically outlasts the aftermarket by three to four years. On an intercom module, aftermarket audio boards are fine and we use them regularly. We are an independent service provider, not affiliated with FAAC, and we stock both OEM and vetted aftermarket parts so the decision is yours.

Signs Your FAAC Keypad & Intercom Repair Is Failing

Worker applying epoxy filler to repair a black metal gate post
Signs Your FAAC Keypad & Intercom Repair Is Failing
  • Some keys work, others don’t. This is a failed carbon contact pad under the membrane, usually from moisture intrusion. One dead column of keys means the flex ribbon has two or three broken traces from heat cycling. Both are repairable with a new keypad face.
  • The keypad beeps but the gate doesn’t move. The keypad is talking, but the control board isn’t listening. On FAAC boards this is often a blown input optocoupler from a nearby lightning strike, common in Weatherford’s spring storm season. We test the input directly before condemning either part.
  • Intercom audio is one-directional. You can hear the visitor but they can’t hear you, or vice versa. This points to a failed speaker coil or a corroded connector on the intercom module, not a wiring problem. We see it on gates that face the prevailing wind and rain.
  • Codes reset to factory default on their own. The EEPROM on the keypad or the board is losing its memory. This usually means the backup capacitor has dried out. It’s a $30 part, but if the board shows corrosion around the capacitor legs, replacing the whole board is the honest call.
  • The keypad shows weak or blank digits after rain. Water has breached the housing gasket. On FAAC keypads the gasket is a square rubber ring behind the faceplate. Once it flattens out, the display starts ghosting. We replace the gasket and the faceplate together, then photograph the installation so you can see the new seal seated properly.
BeforeBefore
AfterAfter

Replacement Cost & What’s Included

Here’s the pricing reality in Weatherford, in dollars, before anyone picks up a tool:

  • FAAC keypad faceplate replacement: $220 to $310 installed. Includes the new OEM or aftermarket faceplate, gasket, and programming verification.
  • FAAC intercom module swap: $280 to $420 installed. Includes the new module, mounting, and a speaker test from both sides of the gate.
  • Keypad and intercom together: $380 to $480 installed. The lower end applies when we’re already there for one and the other shows early failure signs.
  • Control board input repair: $180 to $320, depending on whether we replace the board or repair the input circuit. We quote this in writing after diagnosis.

Every price above is the complete installed price, parts and labor, written down and handed to you before we begin. That’s Haven Standard Clause 1. No “call for a quote,” no surprise at the end. The work is covered by the 365-Day Done Right Promise: if it fails within a year, we make it right at no charge. Adrian Vance started this company specifically because he watched too many gate owners pay twice to rediscover the same problem. Name what you found, name what it costs, name what you left behind.

DIY or Call Us?

Technician performing metal gate repair with an angle grinder outdoors
DIY or Call Us?

There are two things any Weatherford homeowner can safely check. First, open the keypad housing and look for a blown fuse on the control board. It’s a small glass tube fuse labeled on the silkscreen. Second, check that the wiring terminals are tight and free of green corrosion. That’s where DIY should stop. FAAC keypads and intercoms are low voltage, but they’re wired to control boards that can carry 120V on nearby terminals, and one wrong probe placement can fry the board entirely. We’ve been called in to replace boards that owners damaged while “just testing” with a multimeter. It happens. If the fuse is fine and the terminals are tight, call (940) 353-4158. We’ll diagnose it by wire, not by guess, and leave you the photo log of every reading and every part we touched.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Call Vance Gate Repair Weatherford

Technician using a power drill to perform metal gate repair
Call Vance Gate Repair Weatherford

If your FAAC keypad is eating codes or your intercom went silent after the last storm, call (940) 353-4158. A live person answers, 24 hours a day. We’ll give you a straight answer, a written price before any work starts, and a photographed record of what we found and what we installed. Free estimate, no pressure, no surprise invoice.

Written by Adrian Vance, Owner, Vance Gate Repair Weatherford at Vance Gate Repair Weatherford, serving Weatherford and nearby areas.

Need Gate Repair help in Weatherford? Licensed & insured · 60-minute response · free estimates
Call (940) 353-4158
Local Service Coverage

Request a Free Estimate in Weatherford

Tell us what you need - Vance Gate Repair Weatherford responds fast. No obligation.

By clicking submit, you confirm you have read our Privacy Policy and agree to be contacted through phone, text, or email concerning your request, including by the partner businesses that may perform the service.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch